NEC DT820 ITY-8LDX - Using Enhanced Programmable Keys; To Pick up a Ringing Call to a Member of Your Workgroup; To Place a Call to a Member of Your Workgroup; Workgroup Features (Enhanced BLF Keys)

MICROBROWSER AND ENHANCED PROGRAMMABLE KEYS
Using Enhanced Programmable Keys
8 -108 DT820 Phone User Guide
• Transfer: Transfer allows the phone user to perform a transfer of the connected call
or held call that is in focus to the Subscribed Address. A Transfer operation on a
non-connected call or held call that is not in focus has no operation.
• Call Back: Call Back functionality allows the phone user to set call back on a
Subscribed Address. When that address becomes idle, the phone notifies the user
by providing visual and audible indications through the key LED and by playing a
soft ring. On receiving the notification, the user can place a call to the Subscribed
Address either by pressing the Call soft key or by dialing the address using the
keypad.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
USING ENHANCED PROGRAMMABLE KEYS
WORKGROUP FEATURES (ENHANCED BLF KEYS)
Note: Transfer operations cannot be completed if the person you are trying to
transfer the call to places you on hold, or if the call from you is placed in a held
state before the transfer operation completes. The operation fails and you
remain connected to the caller the same as before you started the transfer
operation.
SINGLE PRESS BEHAVIOR
To place a call to a member of your workgroup
You can use a programmed key to directly place calls to another member of your
workgroup.
• While your phone and the other workgroup member’s phone is idle, do one of the
following:
• To make a hands-free or headset call: Press the key for the workgroup
member you want to call, then use your headset or the phone’s speaker to
continue the call on your phone.
• To use your phone handset for the call: Pick up your phone handset, then
press the key for the workgroup member to continue the call on your phone.
To pick up a ringing call to a member of your workgroup
If you are set up for a workgroup, you will see a flashing green LED when there is a
ringing call on any other workgroup member’s phone.
• While your phone is idle and the other workgroup member’s phone is ringing, do one of
the following:
• To place a hands-free or headset call: Press the key for the workgroup
member, then use your headset or the phone’s speaker to continue the call on
your phone.
• To use your phone handset for the call: Pick up your phone handset, then
press the key for the workgroup member to pick up the call.