NEC DT820 ITY-8LDX - To Connect LAN Cable to the Phone; To Connect a Headset (Optional)

INSTALLATION
3 -30 DT820 Phone User Guide
Figure 3.6 Handset Connection
To connect LAN cable to the phone
You will need a 10 BASE-T/100 BASE-T/TX LAN cable (Straight) to connect the
phone to your network.
1 Connect the 10 BASE-T/100 BASE-T/TX LAN cable to the LAN port on the phone and to
an open port on a device such as a Hub or PoE (Power Over Ethernet) switch on the
local area network.
2 Thread the LAN cable through the groove on the bottom of the tilt leg.
Figure 3.7 Phone/LAN Connection
To connect a headset (Optional)
Note: For information on connecting a Jabra Bluetooth headset to your phone, see
Appendix C , “EHS Bluetooth® Headset Support.”
1 Press the Menu key on the phone.
2 Select 3 User Settings.
3 Select 2 Headset.
4 Select 1 Enable/Disable.
5 Select 2 Enable.
6 Press Enter b on the cursor pad or the OK softkey to accept the setting.
7 Insert the headset cord plug into the HEADSET connector on the back of the phone, until
you hear a click.