42
(8) Press Hold.
(9) Press the Speaker key to hang up.
Line Keys/Programmable Function Keys
The following functions can be assigned to Line Keys if
allowed by Class of Service.
To Program a Line key as a Programmable Function
Key:
(1) Press the Speaker key.
(2) Dial Service Code 751.
(3) Press the Line Key to be programmed.
(4) Dial the code for the desired feature plus
additional data if required.
(5) Press Speaker to hang up.
Note: Service Code 00 will erase the function from the key.
Note: In some cases, the Hold key needs to be pressed
before pressing the Speaker key.
4 Enter characters: G-I, g-I, 4
5 Enter characters: J-L, j-l, 5
6 Enter characters: M-O, m-o, 6
7 Enter characters: P-S, p-s, 7
8 Enter characters: T-V, t-v,8
9 Enter characters: W-Z, w-z,9
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü á å è
* Enter characters:
+ , - . / : ; < = > ? B E ó S ¢ £
# # = Accepts an entry (only required if
two letters on the same key are
needed – ex: TOM). Pressing # again
= Space.
Conf Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Name).
Exit Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Number, this
clears both the number and name).
Use this
keypad
digit....
Key for Entering Names
When you want to....
Function
Number
Function Additional Data
00
Not Defined
01
DSS / One-Touch
Extension number or any
numbers (up to 24 digits).
Press HOLD to write.
02
Microphone Key
(ON/OFF)
03
DND Key
04
BGM (ON/OFF)
05
Headset
06
Transfer Key
07
Conference Key
To Next Page
Loading...
