System Cabling A-5
A
– Diskette drive connector
H
– Ultra2 SCSI interface cable
B
– Diskette interface cable
I
– Optional SCSI removable media devices
C
– Diskette drive
J
– Ultra-160/M SCSI connector (68 pin)
D
– IDE connector
K
– Ultra-160/M SCSI interface cable
E
– IDE interface cable
L
– Four SCSI disk drives
F
– IDE CD-ROM drive
M
– System board
G
– Ultra2 SCSI connector (68 pin)
Figure A-2. Standard System Cable Configuration (Standard Drive Bay)
RAID Configuration
The RAID options available for your system provide your system with the added
security of fault tolerance.
If you order a system with a RAID controller, the system is pre-cabled at the factory
(see "RAID System Cabling Configuration" figures below.)
If you are adding a RAID controller you must install, cable, and configure the
controller. Refer to "Installing a RAID Controller Board" in Chapter 4.
To Next Page
Loading...
