Upgrading Your System 4-23
Installing or Swapping a Hard Disk Drive in a Standard SCSI
Disk Drive Bay
This procedure describes installing a new hard disk drive or swapping out a
faulty drive from the SCSI disk drive bay. The drive bay must be removed
from the system when installing or removing a hard disk drive. Disk drives
must use the industry standard 68-pin Wide SCSI interface connector.
Note:
To order a hard disk drive, contact your sales
representative or dealer.
!
If installing new drives, follow an installation scheme starting with the
left-most drive. Fill the bays right-to-left (1 through 4). See Figure 4-19.
0 1 2 3 4 5
1 234
Figure 4-19. SCSI Disk Drive Installation Scheme
!
The suggested hard disk SCSI address assignment is:
Bay Device SCSI ID Address
1 First Hard Disk (Right) 0
2 Second Hard Disk 1
3 Third Hard Disk 2
4 Fourth Hard Disk (Left) 3
To Next Page
Loading...
