NEC Express5800 120Ld - Clearing and Changing the Passwords

3-22 Configuring Your System
Clearing and Changing the Passwords
To clear and change the passwords:
1.
Power off the system and remove the left panel as described in chapter 4 of
this guide.
2.
Remove the spare jumper from position 6 on jumper block 1M5.
3.
Reinstall the spare jumper on position 2 (Password Disable) of jumper block
1M5. Refer to the previous illustration “System Board Jumpers” to find the
location of this jumper.
4.
Power on the system and while waiting for POST to complete, press the F2
key to enter BIOS setup. This automatically clears all passwords, provided
you exit and save the BIOS setup.
5.
Power off the system.
6.
Remove the Password Disable jumper from pins 3-4.
7.
Replace the panel and power on the system.
8.
To specify a new password run the BIOS Setup Utility as described earlier
in this chapter.