4-28
Upgrading Your System
Figure 4-24. Removing the Diskette Assembly Mounting Screw
6.
Slide the diskette assembly to the rear of the system to release the bracket
from the removable media drive cage. See Figure 4-25.
Figure 4-25. Removing the Diskette Assembly
7.
Remove the diskette and mounting bracket from the system and place the
assembly on an antistatic surface.
8.
If you are replacing the diskette drive, remove the four screws securing the
diskette drive to the mounting bracket.
9.
Reverse Steps 1 through 8 to install a replacement diskette drive.
To Next Page
Loading...
