Upgrading Your System 4-31
10.
Install the media device into the bay as follows:
!
Move any cables in the bay out of the way.
!
Align the rails on the media device with the supports in the bay.
A
Figure 4-30. Installing a Removable Media Device
!
Slide the device into the bay until the right slide rail is against the system
cabinet. See Figure 4-30, A.
11.
Secure the right side of the device to the system with the screw supplied.
See Figure 4-30, A.
12.
Secure the left side of the device to the device bay with two screws supplied.
See Figure 4-31, A.
A
Figure 4-31. Securing a Removable Media Device
13.
Connect the interface and power cable to the device.
14.
Replace the left side panel and close the front panel.
15.
Plug in the system power cord, and power on the system.
To Next Page
Loading...
