C-10 Emergency Management Port Console
n Serial Line - must be filled out when the line selection is set to Direct connect
(Serial Line).
Baud Rate - must be 19200 for EMP to connect properly.
COM Port No. - set the COM Port number to which the null modem serial
cable is connected.
n Connect - initiates connection to the connected server. When this button is clicked,
you are prompted for the EMP password.
n Config - displays the Phonebook dialog.
n Cancel - exits the Connect dialog without any action taken.
n Help - displays dialog level help information.
Power On/Off
Selecting Power On/Off from the Action menu allows you to power the server on or off,
with post-power-up options. It generates the Power on/off dialog.
Power On/Off Dialog
Options available in the dialog are:
n Power ON - powers on the server.
n Power OFF - powers off the server. This option is not allowed if the server is
configured in RESTRICTED mode for EMP operations.
n Post-power-up option - sets the mode selection of the server to EMP active or
BIOS redirection. The setting is available after the next power-up. The default
selection is EMP active.
n Cancel - exits the dialog without any action taken.
n Help - displays dialog level help information.
To Next Page
Loading...