NEC Express5800/120Lh Operation Manual for Microsoft®Windows Server™ 2003 x64 Editions
10
5. Press the <F6> key while "Setup is inspecting your computer's hardware
configuration.." is displayed in the upper part of the screen.
TIPS
• Pressing the <F6> key does not change the screen display.
• When SATA HostRAID or SCSI HostRAID is used, a RAID drive must be
created in advance. Refer to the description of RAID configuration in
the user's guide.
• When an optional disk array controller is used, refer to the manual
supplied with the board.
When the <F6> key need not be pressed, the subsequent steps are unnecessary.
Perform setup operation according to the instructions displayed on the screen. For
details, refer to "First Step Guide".
6. When the following message is displayed, press the <S> key:
The following message is displayed:
7. Set the Windows Server 2003 x64 Edition OEM-DISK for EXPRESSBUILDER in the
floppy disk drive, and press the <Enter> key.
A list of SCSI adapters is displayed.
Please insert the disk labeled
Manufacturer-supplied hardware support disk
into Drive A:
* Press ENTER when ready.
Setup could not determine the type of one or more mass storage
devices installed in your system, or you have chosen to
manually specify an adapter. Currently, Setup will load
support for the following mass storage device(s).
To Next Page
Loading...
Need help?
General
