NEC Express5800/120Lh Operation Manual for Microsoft®Windows Server™ 2003 x64 Editions
20
When the Express5800 series cannot operate as intended, check the Express5800 series
according to the check list given below before sending it to be repaired.
If a symptom in the list is observed, perform checking and take action as indicated
subsequently.
If the system still does not operate normally, record the messages displayed on the screen
of the display unit, and contact the maintenance service company.
The symptoms listed in the following troubleshooting are symptoms that are newly observed
in the Windows Server 2003 x64 Editions. For other symptoms, refer to the user's guide.
When the Windows Server 2003 x64 Editions have been installed, the following
event log may be recorded:
Source: DCOM
Type: Error
Event ID: 10016
Explanation: According to the default authority setting in the computer,
the access permission for performing local activation of a
COM server application having CLSID
{555F3418-D99E-4E51-800A-6E89CFD8B1D7} cannot be
given to user NT AUTHORITY¥LOCAL SERVICE SID
(S-1-5-19). This security access permission can be
changed by using the component service management
tool.
→ This poses no system operation problem.
When the Windows Server 2003 x64 Editions have been installed, the following
event log may be recorded:
Source: LoadPerf
Type: Error
Event ID: 3009
Explanation: The character string of the performance counter of service
C:¥WINDOWS¥syswow64¥ipsecprf.ini
(C:¥WINDOWS¥syswow64¥ipsecprf.ini) could not be
installed.
The error code is the first DWORD in the data section.
→ This poses no system operation problem.
Troubleshooting
To Next Page
Loading...
Need help?
General
