NEC Express5800/120Lh Operation Manual for Microsoft®Windows Server™ 2003 x64 Editions
6
Re-
Installation on a Dynamic Disk
When the hard disk drive that has been upgraded to a dynamic disk is used for
re-installation, if there is a partition other than the partition in which the OS is installed,
and you want to keep that partition, note the following:
• As the partition where the OS is to be installed, select the partition where the OS
was installed before.
• For the OS partition format, select "Use the current File System".
Magneto-optical drive
When NTFS is set for the file system with a magneto-optical drive left connected at the
time of installation, file system conversion may not be performed correctly.
If correct file system conversion is not performed, remove the magneto-optical drive, and
perform the installation from the beginning.
DAT and Other Media
During setup, do not set any media such as a DAT that are not required for installation.
Updating BIOS
Before the Windows Server 2003 x64 Editions can be installed, BIOS for the Windows
Server 2003 x64 Editions may have to be updated by using the EXPRESSBUILDER
CD-ROM.
To determine whether BIOS update is required or not, visit the download site and check
for any supported module.
For the update procedure, see the introductory statements presented at the time of BIOS
downloading to each device and "Readme.txt" included in downloaded data.
To Next Page
Loading...
Need help?
General
