NEC Express5800/120Lh Operation Manual for Microsoft®Windows Server™ 2003 x64 Editions
9
This chapter explains how to newly install the Windows Server 2003 x64 Editions.
1. Turn on the power to the system.
Update BIOS for the Windows Server 2003 x64 Editions if necessary.
To determine whether BIOS update is required or not, visit the download
site and check for any supported module.
A description of POST (Power On Self-Test) is displayed on the display screen.
(If the "NEC" logo is displayed, press the <Esc> key.)
In a little while, the following message appears in the lower left part of the screen:
Press <F2> to enter SETUP
2. Press the <F2> key, select "Advanced" from the BIOS Setup menu, and set "Installed
O/S" to "PnP O/S". The setting method varies from model to model. For details,
refer to "Readme.txt" included in the BIOS download data of the device.
3. From the BIOS Setup menu, select "Exit" → "Save Changes & Exit", and select [Yes]
to restart the system.
4. Set the Windows Server 2003 x64 Edition CD-ROM or backup CD-ROM in the
CD-ROM drive,
then perform
a reset o
perati
on
(by press
ing the <Ctrl>+<Alt>+<Del>
keys) or turn the power off then on again to restart the NEC Express5800 series.
When an OS that is ready for operation is already installed on the hard
disk, press the <Enter> key while "Press any key to boot from CD..." is
displayed on the screen. This operation is unnecessary if there is no
OS that is ready for operation.
The system starts from the CD-ROM, starting the installation program.
The Windows Server 2003 x64 Editions setup screen appears. If the screen does
not appear, the <Enter> key was not pressed correctly. Turn on the power to the
system again, and start the steps from the beginning.
1 Installing Windows Server 2003 x64 Editions
To Next Page
Loading...
Need help?
General
