NEC GT200 - For SV8300; For SV8100

Chapter 3 MMI Configuration
16
2. Press the MENU/EXIT key, then use the UP and DOWN keys to switch from YES/NO. Press SELECT again to
confirm or to cancel and return to previous menu level.
Note: If you have more than one SIP account, repeat the settings in step 1 to configure additional SIP accounts.
For SV8300
1. Select one of the ten SIP accounts to display the submenu. The following items are required:
 Registration: Enable / disable this account, set to “Enable” on SV8300.
 Send Register: Enable / disable sending SIP account information, set to “Enable” on SV8300.
 Reg. ID: Input the registration ID, it is “Extension number” registered on SV8300.
 Display Name: Input the user name. The user name will be shown on the terminal display when the phone is
idle.
 Auth. Name: Input the Authentication Name used for authentication. It can be identical to or different from SIP
Registration ID. It is “Extension number” registered on SV8300
 Password: Input the register password.
 Reg. Server: Input the registration server IP address, “(IP Address of SV8300): (port number)”, a port number
is required. The default value of the SV8300 is “5070”
 Reg. Port: Input the registration server Port.
 Proxy Server: Input the proxy server IP address.
 Proxy Port: Input the proxy server port number.
 Outbound Proxy: Input the outbound proxy server IP address.
 Outbound Proxy Port: Input the outbound proxy server port number.
 Expire time: User can set the timeout duration for registration request, it should be “120” or more.
 DTMF Type: Input the DTMF type options: RFC2833 / In-Band
 Keep Alive: To keep connected to the server by period time. Typically enabled to instruct the phone to send
SIP keep-alive message for maintaining a “pinhole” in the user’s firewall through which SIP messages can pass.
 MWI: Enable / disable to ask server auto provide Message Waiting Indicator.
 Voice Mail: Input the speed dial number for your SIP reg. server or IP-PBX Voice Mail system.
 Save: To save your settings.
2. Press the MENU/EXIT key, then use the UP and DOWN keys to switch from YES/NO. Press SELECT again to
confirm or to cancel and return to previous menu level.
Note: If you have more than one SIP account, repeat the settings in step 1 to configure additional SIP accounts.
For SV8100
1. Select one of the ten SIP accounts to display the submenu. The following items are required:
 Registration: Enable / disable this account, set to “Enable” on SV8100.
 Send Register: Enable / disable sending SIP account information, set to “Enable” on SV8100.
 Reg. ID: Input the registration ID, it is “Extension number” registered on SV8100.
 Display Name: Input the user name. The user name will be shown on the terminal display when the phone is
idle.
 Auth. Name: Input the Authentication Name used for authentication. It can be identical to or different from SIP
Registration ID. It is “Extension number” registered on SV8100
 Password: Input the register password.
 Reg. Server: Input the registration server IP address, “(IP Address of SV8100): (port number)”, a port number
is required. The default value of the SV8100 is “5070”
 Reg. Port: Input the registration server Port.
 Proxy Server: Input the proxy server IP address.
 Proxy Port: Input the proxy server port number.
 Outbound Proxy: Input the outbound proxy server IP address.
 Outbound Proxy Port: Input the outbound proxy server port number.