NEC GT200 - LAN Port Settings; Static IP; To Configure Static IP Settings; To Configure Pppoe Settings

Chapter 4 Web Configuration
33
LAN Port Settings
1. To configure IP settings through the web browser:
2. Click Network, LAN Port Settings. The following screen will be displayed.
Static IP
To configure Static IP settings:
1. Select Static IP in IP Type.
2. The following fields are enabled for user input. Enter the required information.
 IP Address: Enter the IP address.
 Netmask: Enter Net Mask.
 Gateway: Enter the Gateway IP.
 Primary DNS: Enter the primary DNS server.
 Secondary DNS: Enter the secondary DNS server. Network connects to this server in case the primary
DNS server is not available.
 Mac Address: Enter the Mac address.
3. Click Submit to save your settings or Reset to cancel.
PPPoE
To configure PPPoE settings:
1. Select PPPoE in IP Type.
2. The PPPoE Setting section is enabled for user input. Enter the required information.
 Username: Enter user name.
 Password: Enter the password of PPPoE settings.
 Keep Alive Mode: Select option, Ping DNS1 or Ping Remote IP.
 Remote IP: Enter remote IP address.
3. Click Submit to save your settings or Reset to cancel.