NEC HT410 - Connecting the Supplied Power Cable

E-20
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable's two-pin plug to the AC IN of the projector, and then connect the other
plug of the supplied power cable in the wall outlet.
2. INSTALLATION AND CONNECTIONS
C
O
N
T
R
O
L
C
O
M
P
O
N
E
N
T
I
N
C
O
M
P
U
T
E
R
IN
V
I
D
E
O
I
N
A
U
D
I
O
IN
S
-V
ID
E
O
IN
R
C
r
/
P
r
C
b
/
P
b
Y
L
/
m
o
n
o
A
U
D
IO
I
N
L
A
M
P
S
T
A
T
U
S
P
O
W
E
R
O
N
/
S
T
A
N
D
B
Y
A
U
T
O
A
D
J
.
A
C
I
N
CAUTION
Do not unplug the power cable from the wall outlet under any one of the following circumstances.
Doing so can cause damage to the projector:
* While the projector is turned on.
* While the cooling fans are running. (The cooling fans continue to work for 60 seconds after the projector
is turned off).