NEC MultiSync LCD3215 User Manual

English-23
English
IR CONTROL Selects the infrared wireless remote controller mode.
The item in this menu will become effective by pressing “SET” button on the selected item.
NORMAL The monitor will be controlled normally by wireless remote controller.
LOCK Disables the monitor control by infrared wireless remote controller.
Keep pressing “DISPLAY” button during 5 sec or more, this setting will return to “NORMAL”.
TILE MATRIX Allows one image to be expanded and displayed over multiple screens (up to 16) through a
distribution amplifier.
H MONITORS Selects number of monitors arranged vertically.
V MONITORS Selects number of monitors arranged horizontally.
POSITION Selects which section of the tiled image to be displayed on the monitor.
TILE COMP Turns the TILE COMP feature on.
ENABLE Enables the Tile Matrix.
PIP and STILL will be disabled when “TILE MATRIX” is activated.
POWER ON DELAY Adjusts the delay time between being in “standby” mode and entering “power on” mode.
“POWER ON DELAY” time is selectable from OFF, 2, 4, 6, 8, 10, 20, 30, 40 and 50 sec.
MULTIDISPLAY RESET Resets the all settings within the MULTI DISPLAY menu back to factory setting.
POWER SAVE Sets how long the monitor waits to go into power save mode after a lost signal.
Note: When connecting DVI, video card might not stop sending digital data even if image has
disappeared. In this case the monitor does not get to power management mode.
RGB Selecting “ON”, the monitor will go to power management mode when RGB1, 2, 3 sync is lost.
VIDEO Selecting “ON”, the monitor will go to power management mode after about 10 minutes when
DVD/HD and VIDEO input signal is lost.
HEAT STATUS Information of status for COOLING FAN, BRIGHTNESS and TEMPERATURE. COOLING FAN
runs when inside temperature is over a guaranteed limit. In this case warning is displayed on
the screen.
SCREEN SAVER Use the SCREEN SAVER function to reduce the risk of Image Persistence.
GAMMA The display gamma is changed and fixed when “ON” is selected.
COOLING FAN The built in cooling fan is always on when set “ON”.
BRIGHTNESS The brightness is decreased when “ON” is selected.
MOTION Image is slightly expanded and moves 4 directions (UP, DOWN, RIGHT, LEFT) periodically
(Need setting the time for movement).
Movement area is approximately +/- 10 mm from original position;
Please locate the important information such as text within 90% area of screen image.
See note (1) for this functions. PIP and STILL will be disabled when “MOTION” is active.
SIDE BORDER COLOR Selects the side black bar color white when 4:3 image displayed, you can select OFF, 50
and 100.
DISPLAY PROTECTION Resets the all settings within the DISPLAY PROTECTION menu back to factory setting.
RESET
MULTI DISPLAY
DISPLAY PROTECTION

NEC MultiSync LCD3215 Specifications

General

Pixel pitch	0.511 x 0.511 mm
Aspect ratio	16:9
Response time	9 ms
Display diagonal	32 \
Display resolution	1360 x 768 pixels
Vertical scan range	50 - 85 Hz
Horizontal scan range	31.5 - 91.1 kHz
Contrast ratio (typical)	800:1
Display number of colors	16.78 million colors
Display brightness (typical)	500 cd/m²
Audio input	Yes
DVI-D ports quantity	1
DVI-I ports quantity	0
Product color	Black
Market positioning	-
Panel mounting interface	400 x 200 mm
Power consumption (typical)	115 W
Operating temperature (T-T)	5 - 40 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth (without stand)	133 mm
Width (without stand)	789 mm
Height (without stand)	476.3 mm
Weight (without stand)	13100 g