NEC N331i - Default Mode Settings; Editing the Mode Settings

16
Default Mode settings
When a mode is selected, some of your phone’s settings are altered automatically to the respective mode.
The following table shows the default settings for each mode.
2
When the selected mode is Car, the backlight is always set to On. This will reduce battery life.
2
The default settings shown above may vary. Be sure to check the setting data with your phone.
Editing the Mode settings
☛
With the standby screen displayed, press the
▲
key. Then use the ▲ and ▼ keys to highlight the required mode and press Softkey 1 before
performing the following procedures.
2
You can also access the Phone modes screen by pressing 1 and 2 from the standby screen.
Ringer
☛
Press 1 to display the list screen that includes the currently set melody.
☛
Use the ▲ and ▼ keys to highlight the desired Ringer, then press .
/
See also: “Sounds” on page 76.
Ringer volume
☛
Press 2 to display the Ringer volume screen with a volume slider.
☛
Use the
▲
or Side up key to increase or the
▼
or Side down key to decrease the volume setting to the level required (the slider moves in the
direction corresponding to the key pressed). Or press a number key (0-Quiet to 9-Loud) for the volume level.
☛
Press Softkey 1 to save the current Ringer volume setting.
Normal mode Meeting mode Pocket mode Car mode
Ringer Default melody Default melody Default melody Default melody
Ringer volume Medium Quiet Loud Medium
Msg tone Default melody Default melody Default melody Default melody
Msg tone volume Medium Quiet Loud Medium
Key tone On Off On On
Service tone On Off On On
Vibrator On On On Off
Auto answer Always OffAlways OffAlways Off On