NEC NP-PX700W - 3 Turning on the Projector

16
2. Projecting an Image (Basic Operation)
 Turning on the Projector
NOTE:
• Theprojectorhastwopowerswitches:AmainpowerswitchandaPOWERbutton(POWERONandOFFontheremotecontrol)
•Turningontheprojector:
1. PressthemainpowerswitchtotheONposition(I).
The projector will go into standby mode.
2. PressthePOWERbutton.
The projector will become ready to use.
•Turningofftheprojector:
1. PressthePOWERbutton.
The confirmation message will be displayed.
2. PressthePOWERbuttonagain.
The projector will go into standby mode.
3. PressthemainpowerswitchtotheOFFposition(O).
The projector will be turned off.
Remove the lens cap.
1. PressthemainpowerswitchtotheONposition(I).
The projector will go into standby mode. When in standby
mode, the POWER indicator will light orange and the STA-
TUS indicator will light green when [NORMAL] is selected
for[STANDBYMODE].SeethePowerIndicatorsection.
(→ page 227)