NEC P452W - ❸ Part Names of the Projector; Front; Mounting the Lens Cap Strap

4
1. Introduction
❸ Part Names of the Projector
Front
Remote Sensor
(→ page 9)
Lens shift dials (Horizontal/Vertical)
(→ page 17)
Lens Cap
Tilt Foot
(→ page 20)
Model name
Model name is indicated on the bot-
tom face of the projector
Wireless LAN cover
(→ page 83)
Exhaust Vent
Focus Ring
(→ page 19)
Lamp cover
(→ page 119)
Remote Sensor
(→ page 9)
Zoom Lever
(→ page 19)
Lens
IntakeVent
(→ page 113)
Mounting the lens cap strap
1. Insert the tip of the strap into the lens cap mount hole and pass
the knot through.
Lens cap mount hole
2. Insert the knot into the strap mount hole (large) on the bottom of
the projector, then press it into the narrow (small) hole.