NEC P452W - ❾ Turning off the Projector

24
2. Projecting an Image (Basic Operation)
❾ Turning off the Projector
Toturnofftheprojector:
1. First, press the (POWER) button on the projector
cabinet or the STANDBY button on the remote control.
The confirmation message will be displayed.
• Theconrmationmessagedisplayedwhenthepower
is turned off indicates the amount of CO
2
reduction this
session and lamp life remaining (→ page 29).
2. Secondly, press the ENTER button or press the
(POWER) or the STANDBY button again.
The lamp and the power are turned off and the cooling
fan stops to rotate, the projector goes into the STANDBY
MODE. When in standby mode, the POWER indicator
will light red and the STATUS indicator will turn off when
[NORMAL] is selected for [STANDBY MODE].
Power On
Steady blue light
Fan rotating Standby
Blinking orange
light
Steady red light
3. Mount the lens cap.
Put the top side of the lens cap to the right position on the
cabinet and push in the bottom side. The stopper is secured
to the projector.
Stopper
CAUTION:
PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbutton.
Becarefultohandletheprojector.
NOTE:
• WhilethePOWERindicatorisblinkingblueinshortcycles,thepowercannotbeturnedoffbyusingthepowerbutton.
• Youcannotrunoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.
• Waitforabout10secondstoturnoffthepoweraftermakingadjustmentorchangeoneachsettingandcloseitsmenu.Ifthe
poweristurnedoffduringthisperiod,theadjustmentandchangemayberesetatdefaultsetting.
• Donotdisconnectthepowercordwhilethecoolingfanremainstorotate.Itmaybecauseofmalfunction.