To Next Page

To Previous Page

130

5. Using On-Screen Menu

TurningOntheProjectorbyDetectingInputSignal[AUTOPOWERONSELECT]

Undertheconditionof[NETWORKSTANDBY],otherwiseundertheconditionof[HDBaseTSTANDBY]ifyouuseHD-

BaseTmodel,theprojectorautomaticallydetectsandprojectssynchronizingsignalinputfromtheselectedterminals

amongComputer,HDMI1/2,DisplayPort,andHDBaseTbythisfunction.

OFF �� AUTO POWER ON SELECT function becomes inactive�

HDMI1, HDMI2, DisplayPort, COMPUTER, HDBaseT*

�� When the projector detects the computer signal input from the selected terminal, automatically it will be

turned ON and will project the computer screen�

* ThisisnotindicatedonMMmodels.

NOTE:

• IfyouwanttoactivatethisAUTOPOWERONSELECTfunctionafterpoweringOFFtheprojector,interruptsignalfrominputterminals

orpulloutthecomputercablefromtheprojectorandwaitforover3secondsandtheninputsignalfromtheselectedterminal.

Incasecomputersignaliscontinuouslyinputtotheprojector,howevertheprojectoristurnedOFFandisinthetransitionto

NETWORKSTANDBYmode,itwillkeepNETWORKSTANDBYmodeandwillnotbeturnedONautomatically.Inaddition,ifsignal

fromHDMI1/2,DisplayPortorHDBaseTiscontinuouslyinputtotheprojector,theprojectormaybeturnedONagainautomatically

basedonthesettingofexternaldeviceseveniftheprojectoristurnedOFFandintheconditionofNETWORKSTANDBYmode.

• Thisfunctionisnotactivatedeitherbycomponentsignalinputfromthecomputerscreeninputterminalorcomputersignalas

SynconGreenandCompositeSync.

Enabling Power Management [AUTO POWER OFF]

Whenthisoptionisselectedyoucanenabletheprojectortoautomaticallyturnoff(attheselectedtime:0:05,0:10,

0:15,0:20,0:30,1:00)ifthereisnosignalreceivedbyanyinputorifnooperationisperformed.

NOTE:

• [AUTOPOWEROFF]willnotworkwhenprojectingsignalsfromtheEthernet/HDBaseTportinHDBaseTmodels.[AUTOPOWER

OFF]worksevenwhentheviewerornetworkisbeingprojectedinMMmodels.

• Whenthe[STANDBYMODE]issetto[HDBaseTSTANDBY]([NETWORKSTANDBY]forMMmodels),[AUTOPOWEROFF]will

turngreyincolorand[0:15]willbeselectedcompulsorily.

Using Off Timer [OFF TIMER]

1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00, 16:00.

2. Press the ENTER button on the remote control.

3. The remaining time starts counting down.

4. The projector will turn off after the countdown is complete.

NOTE:

• Tocancelthepresettime,set[OFF]forthepresettimeorturnoffthepower.

• Whentheremainingtimereaches3minutesbeforetheprojectoristurnedoff,the[THEPROJECTORWILLTURNOFFWITHIN3

MINUTES]messagewillbedisplayedonthebottomofthescreen.

NEC PA521U User Manual

Other manuals for NEC PA521U