NEC PC-8201A - Page 116

Giapter 6
f.7/C0NT
SYNTAX:
CONT
FUNCTION:
Restarts the execution of a program that was previously stopped.
DESCRIPTION:
The Key, Q + C Key, or the STOP statement in BASIC are
used to halt program execution. Once stopped, investigation of a
possible error can be achieved in the direct mode. The CONT
command is then used to re-start (continue) the program. The
program will resume execution where the halt occurred. To
continue program execution simply press the f.7 Key (Qjjj^and f.2)
or input “CONT" and then press the Key.
The CONT command cannot be executed if the contents of the
program have been altered after the STOP occurred.
6-17