NEC PC-8201A - Page 160

Giapter 8
f.4/STAT
FUNCTION:
This command changes the previous communication format to a new
format, which will be saved as the default value.
DESCRIPTION:
When STAT is input without adding any parameters, TELCOM
indicates the current communication format. In order to change
the communication format, utilize the STAT command with a
six-character parameter attached after the command, as follows:
STAT < CPBSXS )
where CPBSXS stands for:
C Communications speed (BAUD RATE)
P Parity
B Word length
S Stop bit
X Control according to "x" parameter
S Control according to shift in/out sequence
Each different character of the parameter is controlled by a different
feature of the communication format.
The following are the values for each different feature of the
communication format:
VALUE COMMUNICATION SPEED
(Baud Rate)
1 : 75 bps
2 110 bps
3 300 bps
8-5