NEC PC-8201A - Page 181

Chapter 8
ESC + Y < y) < x )
The cursor position is designated vertically and horizontally by two
characters which are subsequent to Q + Y.
Capital letters from character code 32 are used in the designa¬
tion. A blank (space) corresponds to the location 0, and (!)
corresponds to 1, while (") corresponds to 2. For instance, to
move the cursor to home position, input the following string:
ESC, "Y", " ", " "
This means 27, 89, 32, 32 in character code.
I-K In TERM mode, when the Key is input, only the
i/ carriage return code (13) is transmitted while the change
line code (10) is not transmitted. In the case where the
carriage return code is received, the line is not chang¬
ed. Though this does not cause a problem in com¬
munication with a host computer, when communicating
with other computers the user must input Q + J in
order to actively perform the change of lines.
No change' line code will be transmitted when the UPLOAD
command is executed. This is something to be fully aware of when
a program is being created at the receiving end of the data
transmission.
The interruption of data transmission is due to an error, which is
avoided if "X" parameters are not used. The data being received
can overflow in the buffer. No message will be generated in this
case, so pay attention when the "X" parameter is used.
8-27/(8-28 blank)