NEC Univerge SV8100 - Table 3-2 SV8100 Maximum System Capacities - Blades

UNIVERGE SV8100 Issue 2.00
Configuration Guide 3 - 3
Table 3-2 SV8100 Maximum System Capacities – Blades shows the maximum
number for each blade that can be installed in a system.
These are determined by the maximum blade configuration allowed. When installing
single line sets, DISA, or tie lines, CPU circuits must be allocated for DTMF receivers.
To install single line sets with CO/PBX line access, or when installing immediate-start
tie lines, CPU circuits must be allocated for dial tone detection.
Table 3-2 SV8100 Maximum System Capacities – Blades
Hardware
9.5”
Chassis
19”
Chassis
with CPU
19”
Chassis
without
CPU
19”
Chassis
x4
Comments
Number of Slot(s) for Interface
Package
3 Slots 5 Slots 6 Slots 23 Slots
Common Control Blades:
CD-CP00 1 1 0 1 –
PZ-32IPLA
(32-port VoIP Daughter Board)
1 1 0 1 This unit provides
32 VOIP Gateway
channels
PZ-64IPLA
(64-port VoIP Daughter Board)
1 1 0 1 This unit provides
64 VOIP Gateway
channels
PZ-128IPLA
(128-port VoIP Daughter Board)
1 1 0 1 This unit provides
128 VOIP Gateway
channels
PZ-ME50
(Memory Expansion Daughter
Board)
1101 –
PZ-VM21
(Voice Mail Daughter Board)
1 1 0 1 Does include
modem
Station Blades:
CD-4DIOPB
(4 DID/OPX)
2 5 6 23 When installed as
an OPX blade
CD-4LCA
(4 Single Line Telephone
Interface)
25623 –
CD-8LCA
(8 Single Line Telephone
Interface)
25623 –
CD-8DLCA
(8 Digital Station Interface)
25623 –