EasyManua.ls Logo

NEC Univerge SV8100 - Section 3 Cabling Requirements and Specifications

NEC Univerge SV8100
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UNIVERGE SV8100 Issue 2.00
Configuration Guide 5 - 7
The CD-CP00 provides:
200 trunk ports maximum
512 extension ports maximum
512 ports digital/IP extensions maximum
256 analog ports maximum
256 virtual extensions
Connection for 32/64/128 VoIP Daughter Board (PZ-32IPLA/PZ-64IPLA/
PZ-128IPLA)
Connection for Voice Mail Daughter Board (PZ-VM21)
Connection for Expanded Memory (PZ-ME50)
Supports TAPI 1.x
1 Green Status LED
4 Red Status LEDs
5 diagnostic LEDs which indicate the status of various system functions
During normal operation, the “RUN” LED will be flashing and the remaining
LEDs will be off.
700x700 Time Division Multiplex Switch (TDM Switch)
Digital Phase Locked Loop (DPLL)
SECTION 3 CABLING REQUIREMENTS AND SPECIFICATIONS
This section provides cabling requirements and specifications for various equipment
used in the SV8100 system.
Only the DT300/DT700, D
term
Series i telephones, Aspire Model C, single line
telephones, cordless telephones and wireless telephones discussed in the document
can be installed on the SV8100 system.
To avoid damage to equipment, do not install the
D
term
70 on the SV8100 system. The D
term
70 (DTU/
DTP) terminal uses -24V and has no protection from
the -48V power supply used by the SV8100 system.

Table of Contents

Other manuals for NEC Univerge SV8100

Related product manuals