NEC Univerge SV8100 - Chapter 3 Table 5-7 Cable Connection between the Analog Port and the Single Line Equipment; Figure 5-3 Connecting the DLC Using Twisted 2-Pair Cable; Table 5-4 DT300 Series Loop Resistance and Cable Length; Table 5-5 DT700 Series Loop Resistance and Cable Length

To Next Page

To Previous Page

Issue 2.00 UNIVERGE SV8100

5 - 8 Hardware Specifications

Figure 5-3 Connecting the DLC Using Twisted 2-Pair Cable is a diagram of the

chassis connected with each of the multiline terminals and single line telephones by a

separate twisted 1-pair cable or 2-pair cable (only for multiline terminals).

Refer to the following tables for cabling requirements and specifications:

 Table 5-4 DT300 Series Loop Resistance and Cable Length

 Table 5-5 DT700 Series Loop Resistance and Cable Length

 Table 5-6 Dterm Series i or Dterm IP Terminal Loop Resistance and Cable

Length

 Table 5-7 Cable Connection Between the Analog Port and the Single Line

Equipment

 Table 5-8 Cabling Requirements

Figure 5-3 Connecting the DLC Using Twisted 2-Pair Cable

Table 5-4 DT300 Series Loop Resistance and Cable Length

Terminal or Adapter

By Twisted 1-Pair

Cable (without

AC Adapter)

24 AWG

By Twisted 1-Pair

Cable (with AC

Adapter)

24 AWG

DTL-2E-1 (BK) TEL