UNIVERGE SV8100 Issue 2.00
Configuration Guide 5 - 3
Table 5-2 SV8100 Maximum System Capacities – Blades on page 5-4 shows the
maximum number for each blade that can be installed in a system.
This is determined by the maximum blade configuration allowed. When installing
single line sets, DISA, or tie lines, CPU circuits must be allocated for DTMF receivers.
To install single line sets with CO/PBX line access, or when installing immediate-start
tie lines, CPU circuits must be allocated for dial tone detection.
Expansion:
PZ-BS10
3-jack Expansion Board for
Controlling Chassis
0101 –
PZ-BS11
1-jack Expansion Board for
Expansion Chassis
0013 –
Battery:
CHS LARGE BATT BOX
(External Battery Box)
0114 –
CHSGW SMALL BATT BOX
(Small Battery Box)
1––– –
Fan Box:
CHS2U FAN BOX SET 0 1 1 4 1 is factory
installed with each
chassis
Power Supply:
MPS7101 1 1 1 4 1 is factory
installed with each
chassis
* Dependent on size of system.
Table 5-1 SV8100 Maximum System Capacities – Chassis (Continued)
Hardware
9.5”
Chassis
19”
Chassis
with CPU
19”
Chassis
without
CPU
19”
Chassis
x4
Comments
Number of Slot(s) for Interface
Package
3 Slots 5 Slots 6 Slots 23 Slots
To Next Page
Loading...
