NEC Univerge SV8100 - SECTION 3 START-UP (DEFAULT) INMAIL CONFIGURATION

Issue 7.00
InMail System Guide 1 - 3
SECTION 2 LED INDICATION
1. Power up the system.
 Remove the grounded wrist strap.
 Mount the PZ-VM21 onto CD-CP00.
 Install the CD-CP00 in the SV8100 chassis.
 Turn the chassis power switch to On.
2. Check the InMail LED. See Figure 1-3 Checking LED1.
 Once the system powers up, check LED1 on the InMail daughter board.
LED1 is viewable on the front panel of the CD-CP00.
. LED1 will blink quickly only when the InMail CF is being accessed.
SECTION 3 START-UP (DEFAULT) INMAIL CONFIGURATION
When you install the InMail blade and turn on the system, InMail has the following
default programming:
 Subscriber Mailboxes are enabled for extensions 200-207. The mailbox
numbers are the same as the extension numbers.
 The Automated Attendant does not answer outside calls.
 The InMail does not answer internal calls.
Figure 1-3 Checking LED1