Issue 7.00
InMail System Guide 2 - 139
Setting Up the System SMTP Options
1. 47-18-01: ENABLE SMTP
Enter 1 to enable SMTP email delivery system-wide.
3 By default, SMTP email delivery is disabled (0).
2. 47-18-08: SMTP EMAIL ADDRESS
Specify the email account that the SMTP server will use to process
email sent from the SV8100 (e.g., yourname@emailserver.com).
3 By default, there is no entry for this option.
1. 90-11-11: DNS PRIMARY ADDRESS
Enter the IP address of primary Domain Name Server (DNS).
- The DNS (or name server) is the computer connected to the
internet that converts a domain name (such as
necSV8100.com) to a specific IP address for routing on the
internet. If you want to use a domain name to identify your
SMTP server in the following option, you must make an entry
for this option. The entry is the IP address of your name server.
3 By default, there is no entry for this option.
2. 90-11-12: DNS SECONDARY ADDRESS
Enter the IP address of secondary Domain Name Server (if any).
3 By default, there is no entry for this option.
3. 47-18-02: SMTP SERVER NAME
Enter the name of the SMTP server that will handle email delivery for
the installation site. The SMTP server name is typically similar to
smtp.emailserver.com.
- If you didn’t make a name server entry in the previous entry, you
must enter your SMTP server’s IP address in this option (not its
name).
3 By default, there is no entry for this option.
4. 47-18-03: SMTP PORT NUMBER
Enter
the port (logical connection) the installation site’s email server
uses for SMTP. See Some Common SMTP Settings above for some
typical examples.
3 By default, SMTP uses port 25.
1. If yes:
47-18-04: SMTP ENCRYPTION
Enter 1.
- The system negotiates “behind the scenes” to determine if
encryption should be TLS or SSL, and then adjusts accordingly.
3 By default, this option is disabled (0).
2. If no:
1. Enable SMTP Email Delivery System Wide.
2. Specify the site’s SMTP server name and port.
3. Does the site’s SMTP email server require encryption?
To Next Page
Loading...
