Issue 7.00
InMail System Guide 3 - 385
Keys for Entering Names
47-01-03 Subscriber Message Length (Subs Msg Length)
Use this option to set the maximum length of recorded messages for:
Subscriber Mailbox users dialing RS to record and send a message.
Extension users leaving a message in a Subscriber Mailbox.
Outside Automated Attendant callers accessing a mailbox via a GOTO
command and then dialing RS (77) to record and send a message.
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can be
up to 12 digits long.
Use this keypad
digit . . .
When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→ ← Á À Â Ã Ç É Ê ì ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
Q
Enter characters:
Q + , - . / : ; < = > ? Π Σ σ Ζ ¢ £
#
# = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing # again = Space. (In system
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Conf
Clear the character entry one character at a time.
Hold
Clear all the entries from the point of the flashing cursor and to the
right.
To Next Page
Loading...
