Issue 7.00
3 - 394 Programming
47-02-02 Mailbox Number
Use this option to select the extension number associated with the mailbox
you are programming. Normally, mailbox 1 should use Mailbox Number
101, mailbox 2 should use Mailbox Number 102, etc.
To make programming easier, consider associating a mailbox number with
a station port. For example, mailbox 1 could correspond to port 1, which in
turn corresponds to extension 200.
Be aware that mailboxes beginning with a leading digit of either 0, * and #
are not supported.
. See Subscriber Mailbox on page 2-337 for more.
Options
Digits (7 maximum, using 0~9).
Default
Mailboxes 1~64 = 200~263.
For all other mailboxes, there is no entry.
47-02-03 Number of Messages
Use this option to set the maximum number of messages that can be left in
the Subscriber Mailbox. If a caller tries to leave a message once this limit is
reached, they hear, “That mailbox is full.” InMail then hangs up.
. See Message Storage Limit on page 2-289 for more.
Options
0~99 messages
To conserve storage space, enter 0 for all unused mailboxes.
Default
99 messages for mailbox 1.
20 messages for all other mailboxes.
47-02-04 Message Playback
Use this option to set the Subscriber Mailbox message playback order.
When a subscriber listens to their messages, InMail can play the oldest
messages first (first-in-first-out, or FIFO), or the newest messages first
(last-in-first-out, or LIFO).
. See Message Playback Direction on page 2-281 for more.
Options
0 (FIFO - first-in-first-out, or oldest messages first).
1 (LIFO - last-in-first-out, or newest messages first).
Default
0 (FIFO - first-in-first-out, or oldest messages first).
47-02-05 Auto Erase/Save of Messages (Auto Erase/Save)
Use this option to determine what happens when a Subscriber Mailbox user
completely listens to a new message and then exits their mailbox without
either saving (SA) or erasing (E) the message. Depending on the setting of
this option, InMail either automatically saves or erases the message. If the
To Next Page
Loading...
