NEC Univerge SV8100 - Page 413

Issue 7.00
InMail System Guide 3 - 405
47-03 Group Mailbox Options
Description
Use 47-03 Group Mailbox Options to set up the 32 Group Mailboxes (1~32). A Group
Mailbox is used for Department Group overflow and can be a Subscriber, Call
Routing, Announcement, or Directory Dialing Mailbox.
.
See Routing Mailbox on page 2-321.
. Be aware that mailboxes beginning with a leading digit of either 0, * and # are not supported.
Options
 47-03-02 Group Mailbox Number (Mailbox Number)
When setting up Department Calling Group overflow, the Group Mailbox
Number is the same as the Department Group Master (pilot) number. Use
this option to select the Department Group Master (pilot) number
associated with the Group Mailbox you are programming.
If routing to a Routing Mailbox is required from a Dial Action Table e.g. by
the GOTO option, the Group Mailbox Number, associated with the routing
mailbox, should be used as the ‘data’ entry.
When using a Group Mailbox as an additional resource (for example, as an
extra Directory Dialing Mailbox), you can do the following:
 Assign a pilot number to an unused Department Group in 11-07-01
Department Group Pilot Numbers.
 Be aware that mailboxes beginning with a leading digit of either 0, * and #
are not supported.
 Set up the Group Mailbox in 47-03, using this pilot number in 47-03-02
Group Mailbox Number.
 When 47-03 programming is complete, remove the pilot number
assignment in 11-07-01 Department Group Pilot Numbers.
. Refer to the following:
 See Directory Dialing on page 2-113.
 See Routing Mailbox on page 2-321.
 See Voice Mail Overflow on page 2-359.
Options
Digits (7 maximum, using 0~9).
No entry (Entered by pressing Hold)
Default
No entry.