XEN Topaz NEC Business Solutions Ltd
Features and Specifications Manual Chapter 4 - 101
Doc. No. 8846 - Release 2.0
April 2005
Enable (1) or disable (0) pre-ringing for outside calls.
14-01-02: Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03: Basic Trunk Data Setup - Receive CODEC Gain Type
Customise the transmit and receive levels of the CODEC Gain Types for
each trunk.
14-02-02: Analogue Trunk Data Setup - Ring Detect Type
For each trunk, enable delayed ringing (0) or immediate ringing (1).
14-05-01: Trunk Groups
For Universal Answer, assign trunks to trunk groups (1-25) then go to
Program 14-06 below to set up Trunk Group Routing.
14-06-01: Trunk Group Routing
For Universal Answer, set up trunk routes (1-25) and then go to Program
23-03 below to assign the trunk routes to extensions. An extension user
can use Universal Answer to answer a call if the ringing trunk is in its
assigned route.
14-07-01: Trunk Access Map Setup
Set up the Trunk Access Maps (1-51). This sets the access options for
trunks. Ring Group programming overrides Access Map programming.
15-06-01: Trunk Access Map for Extensions
Assign Trunk Access Maps (1-51) to extensions.
15-07-01: Programming Function Keys
To have outside calls ring specific keys, assign trunks to line keys
(codes 1-51). You can also program function keys as trunk group or loop
keys (*02 or *05). For additional loop key data, in Program 15-13 enter 0
(incoming only), 1 (outgoing only) or 2 (both ways).
20-02-09: System Options for Multi-Line Telephones - Disconnect Supervi-
sion
Enable (1) disconnect supervision for the system.
20-06-01: Class of Service for Extensions
For Universal Answer, assign a Class of Service (1-15) that enables
Program to an extension.
20-10-07: Class of Service Options (Answer Service) - Automatic Answer of
Universal Calls
In an extension’s Class of Service, enable (1) or disable (0) the exten-
sion’s ability to use Auto-Answer to pick up Universal Answer calls. This
allows a user to simply pick up the handset instead of Dialling a service
code.
20-13-23: Class of Service Options (Supplementary Service) - Display the
Reason for Transfer
In an extension’s Class of Service, enable (1) or disable (0) an exten-
sion’s ability to display the Reason for Transfer message.
22-01-02: System Options for Incoming Calls - Incoming Call Ring No
Answer Alarm
To Next Page
Loading...
