Chapter 4 - 156 Features
NEC Business Solutions Ltd XEN Topaz
Doc. No. 8846 - Release 2.0
April 2005
Designate the trunk route accessed when a user dials the Alternate
Trunk Route Access Code. Refer to “Trunk Group Routing” to set up out-
bound routing.
22-01-11: System Options for Incoming Calls -VRS Waiting Message Interval
Time
Setup the sending duration time of the Auto - Attendant & Queuing. The
message is repeatedly sent out within the specified time (0-64800 sec-
onds).
22-02-01: Incoming Call Trunk Setup
For DISA operation, set the trunk service type to 02. You can have a dif-
ferent service type for each Night Service mode.
22-04-01: Incoming Extension Ring Group Assignment
Assign the extensions that should receive the overflow. Set the ringing in
Program 22-06 (0=trunks don’t ring [just flash line keys], 1=trunks ring).
25-03-01: DID/DISA Transfer Ring Group With Incorrect Dialling
Assign the extensions that should receive the overflow. Set the ringing in
Program 22-06 (0=trunks don’t ring [just flash line keys], 1=trunks ring).
25-04-01: DID/DISA Transfer Ring Group With No Answer/Busy
Set the operating mode of each DISA trunk. This sets what happens to
the call when the DISA caller calls a busy or unanswered extension. The
call can either disconnect (0), transfer to an alternate ring group destina-
tion (1-25), or transfer to DSPDB Voice Mail (101).
25-07-01: System Timers for DID/DISA - DISA Dial Tone Time
After answering the DISA trunk, the system waits this interval (0-64800
seconds) for the caller to dial the first digit of the password. If the caller
fails to dial within this interval, the system drops the call.
25-07-02: System Timers for DID/DISA - DID/DISA No Answer Time
A DISA caller can ring an extension for this interval (0-64800 seconds)
before the system sets the call as a Ring No Answer. After this interval
expires, the call follows the programmed Ring No Answer routing (see
Program 25-04 below).
25-07-07: System Timers for DID/DISA -DISA Conversation Warning Tone
Time
Determine the length of time a DISA caller can talk before the Long Con-
versation tone is heard (0-64800 seconds).
25-07-08: System Timers for DID/DISA - DISA Long Conversation Disconnect
This timer determines how long the system will wait before disconnect-
ing a call after the Long Conversation tone is heard (0-64800 seconds).
25-07-09: System Timers for DID/DISA - DISA Internal Paging Time
This is the maximum length of an Internal Page placed by a DISA caller.
If the Page continues longer than this interval (0-64800 seconds), the
system terminates the DISA call.
25-07-10: System Timers for DID/DISA - DISA External Paging Time
To Next Page
Loading...
