XEN Topaz NEC Business Solutions Ltd
Features and Specifications Manual Chapter 4 - 185
Doc. No. 8846 - Release 2.0
April 2005
Determine whether intercom calls should ring or voice-announce exten-
sions (0=voice, 1=ring).
20-02-14: System Options Key Telephones
Headset Ringing Cancel Timer 0-64800(sec.) 30
20-03-06: System Options for Single Line Telephone – Headset Ringing Start
Time (for SLT)
Define the Headset ringing start time. After this timer expires from the
time when a SLT is off hook, the system will set the SLT to headset ring-
ing mode (Default: 5 seconds, Entries: 0-64800).
21-13-38: Class of Service Options (Supplementary Service) – Headset Ring-
ing
In an extension’s Class of Service, enable (1) or disable (0) an exten-
sion’s ability to use the Headset ringing (Default: 0 [disabled]).
30-03-01: DSS Console Key Assignment
When using a DSS Console, assign a function key for Headset opera-
tion (code 05).
• Related Features
• Handsfree Answerback/Forced Intercom Ringing
An extension with a headset can still receive voice-announced Intercom calls and
respond Handsfree.
• Programmable Function Keys
A Headset Function key is required to answer or place a call in headset mode.
• Single Line Telephones
Single line telephones cannot use the Headset feature.
•Operation
To enable the headset:
1. Program a Headset key (PGM 15-07 or SC 851: 05).
You hear a confirmation beep.
To use the headset:
The Headset key lights when you’re on a call. To disconnect, press the Headset key again.
The headset only activates when the Headset key is pressed.
Answer a ringing call by pressing the Headset key.
OR
Press the Headset key and then a line key to make a trunk call.
OR
Press the Headset key to get Intercom dial tone.
OR
If on a call, press the Headset key to hang up.
To Next Page
Loading...
