XEN Topaz NEC Business Solutions Ltd
Features and Specifications Manual Chapter 4 - 269
Doc. No. 8846 - Release 2.0
April 2005
•Operation
To change the function of a General Programmable Function Key:
1. Press CALL key.
2. Dial 851.
3. Press the key you want to program.
4. Enter the 2-digit key function, followed by any additional information required by the
function selected.
5. Press HOLD.
6. Press SPK key.
Available functions are 00-99 (refer to chart SC 851 below) and line keys 01-51. To clear a key, enter 00.
To change the function of an Appearance Programmable Function Key:
1. Press a SPK key.
2. Dial 852.
3. Press the key you want to program.
4. Enter the 3-digit key function and any additional information needed for the key.
5. Press the SPK key.
Available functions are *00-*99 (refer to chart SC 852 below) and line keys 01-51. To clear a key, enter 000.
When a key is programmed using service code 852, that key cannot be programmed with a function using
the 851 code until the key is undefined (000). For example with a Park Key programmed by dialling 852 +
*04 must be undefined by dialling 000 before it can be programmed as a Call Forward key by dialling 851 +
16.
To check the function of a Programmable Function Key:
1. Press CHECK.
Press the programmable key.
The programmed function displays.
To Program a DSS/One-Touch Key:
1. Press CALL.
2. Dial 851.
3. Press the Function Key to program.
4. Dial Extension Number, or 0 + Outside Number.
5. Press HOLD.
6. Press SPK.
Function Number List (00~99) for Service Code 851
Funct.
No.
Function Additional Data LED Indication
00
Not Defined
01
DSS/One-Touch
Extension number or
Trunk Code + Outside No.
(Max. 36 digits)
On (Red): Extension Busy (BLF)
Off: Extension Idle
Rapid Blink (Red): DND or CF Set
02
Microphone Key (ON/OFF)
On (Red): MIC On
Off: MIC Off
03
DND Key Red-On: DND Setup
To Next Page
Loading...
