NEC Xen Topaz - Page 298

Chapter 4 - 290 Features
NEC Business Solutions Ltd XEN Topaz
Doc. No. 8846 - Release 2.0 April 2005
• Programming
15-07-01: Programming Function Keys
Assign a function key for Call Forwarding (Device) (code 17) or Text
Message (code 18). The Call Forwarding Device key allows the user to
select a message each time they activate the feature, while the Text
Message key automatically selects the message used when program-
ming the key.
20-02-07: System Options for System Telephones - Time and Date Display
Mode
Set the System Time and Date display mode. The time that displays in
Selectable Display Messages follows this setting.
20-06-01: Class of Service for Extensions
Assign a Class Of Service (1-15) to an extension.
20-13-19: Class of Service Options (Supplementary Service) - Selectable Dis-
play Messaging
In an extension’s Class of Service, enable (1) or disable (0) an exten-
sion’s ability to use Selectable Display Messaging.
20-16-01: Selectable Display Messages
Program the Selectable Display Messages (1-20). Refer to the chart
below for character entry.
Use this keypad digit
…
When you want to …
1
Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | }_@? ?
2
Enter characters A-C, a-c, 2.
3
Enter characters D-F, d-f, 3.
4
Enter characters G-I, g-i, 4.
5
Enter characters J-L, j-l, 5.
6
Enter characters M-O, m-o, 6.
7
Enter characters P-S, p-s, 7.
8
Enter characters T-V, t-v, 8.
9
Enter characters W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & , ( )
*
Enter characters:
* + , - . / : ; < = > ?
OPAC
Accepts an entry (only required if two letters on
the same key are needed).
DND/CONF
Clear the character entry one character at a
time.
CLEAR
Clear all the entries from the point of the
flashing cursor and to the right.