NEC Xen Topaz - Page 316

Chapter 4 - 308 Features
NEC Business Solutions Ltd XEN Topaz
Doc. No. 8846 - Release 2.0 April 2005
14-01-05: Basic Trunk Data Setup - Receive Gain Level for Conference and
Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an
Unsupervised Conference.
14-01-13: Basic Trunk Data Setup - Loop Supervision
For each trunk that should be able to participate in a tandem call, enter
1.
15-07-01: Programming Function Keys
(Optional) Assign a function key for Transfer (code 06).
20-06-01: Class of Service for Extensions
Assign a Class of Service (1-15) to an extension.
20-13-08: Class of Service Options (Supplementary Service) – Conference
In an extension’s Class of Service, enable (1) or disable (0) the exten-
sion’s ability to initiate a Conference.
20-13-10: Class of Service Options (Supplementary Service) - Barge In Mode
In an extension’s Class of Service, set whether an extension should be
able to Barge In to a call and talk (1) or just monitor the call (0).
20-11-14: Class of Service Options (Hold/Transfer Service) - Trunk-to-Trunk
Transfer
Disable (0) the Trunk-to-Trunk Transfer Restriction option.
Tandem Trunking Method B - Tandem Trunking on Hang Up
14-01-04: Basic Trunk Data Setup – Transmit Gain Level for Conference and
Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an
Unsupervised Conference.
14-01-05: Basic Trunk Data Setup - Receive Gain Level for Conference and
Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an
Unsupervised Conference.
14-01-13: Basic Trunk Data Setup - Loop Disconnect Supervision
For each trunk, enter 1 to enable loop supervision.
14-02-12: Detect Network Disconnect Signal
Enable the network disconnect signal detection for proper release of
analogue trunks.
15-07-01: Programming Function Keys
Assign a function key for Transfer (code 06).
20-06-01: Class of Service for Extensions
Assign a Class of Service (1-15) to an extension.
20-07-11: Class of Service Options (Administrator Level) - Forced Trunk Dis-
connect
In an extension’s Class of Service, enter 1 to enable Forced Trunk Dis-
connect. This allows the extension to disconnect an Unsupervised Con-
ference in progress (initially set up using Method B).