XEN Topaz NEC Business Solutions Ltd
Features and Specifications Manual Chapter 4 - 323
Doc. No. 8846 - Release 2.0
April 2005
• Programming
15-07-01: Programming Function Keys
Extension users may want a function keys programmed for Transfer
(code 06).
20-02-01: System Options for System Telephones - Retrieve the Line After
Transfer
Enable (1) or disable (0) an extension’s ability to answer a call after it’s
been transferred, but before it’s answered.
20-03-01: System Options for Single Line Telephones - SLT Call Waiting
Answer Mode
For a busy single line telephone, set the mode used to answer a
camped-on trunk call:
• 0 = Press and release hookswitch to pick up waiting call
• 1 = Press and release hookswitch and dial Service Code 894 to
answer waiting call
20-06-01: Class of Service for Extensions
Assign a Class Of Service (1-15) to extensions.
20-11-06: Class of Service Options (Hold/Transfer Service) - Unscreened
Transfer
In an extension’s Class of Service, enable (1) or disable (0) the exten-
sion’s ability to use Unscreened Transfer.
20-11-07: Class of Service Options (Hold/Transfer Service) - Transfer Without
Holding
In an extension’s Class of Service, enable (1) or disable (0) the exten-
sion’s ability to use Transfer Without Holding.
20-11-08: Class of Service Options (Hold/Transfer Service) - Transfer Display
In an extension’s Class of Service, enable (1) or disable (0) the exten-
sion’s incoming Transfer pre-answer display.
20-11-11: Class of Service Options (Hold/Transfer Service) - Automatic On
Hook Transfer
In an extension’s Class of Service, enable (1) or disable (0) the exten-
sion’s ability to use Automatic On Hook Transfer. If enabled, user must
press HOLD and dial the extension number to Transfer the call. If dis-
abled, a user must have a Transfer Programmable Function Key. To
transfer the call, the user would press HOLD, dial the extension number,
then press the Transfer Programmable Function key to complete the
transfer.
20-11-18: Class of Service Options (Hold/Transfer Service) - No Recall
If an extension should not receive recalls of unanswered Transferred
calls, disable this option (0=allow recalls, 1=prevent recalls).
24-02-01: System Options for Transfer - Busy Transfer
Prevent (0) or allow (1) extensions to transfer calls to busy extensions.
If disabled, calls transferred to busy extensions recall immediately.
24-02-03: System Options for Transfer - Delayed Call Forwarding Time
To Next Page
Loading...
