NEC Xen Topaz - Page 43

XEN Topaz NEC Business Solutions Ltd
System Hardware Manual Chapter 3 - 35
Doc. No. 8846 - Release 2.0 April 2005
Code: 49 + ext or voice mail
number
Operation: Press key
Call Redirect
Redirecting an
incoming call to an
extension or voice mail
On red when
activated
Flashes when in
DND/Call Forward
Code: 50
Operation: Press key
Account Codes
Entering Account
Codes
None
Code: 52 + Incoming Ring Group
Number (1~8)
Incoming Call Queuing Setup
Busy on a call and wish
to play a delay
message to new callers
to that ring group
On red when active
Code: 53 Queuing Message Starting On red when active
Code: 54
Operation: Press key
Call Forward, Off- Premise
Forwarding a
Doorphone call to an
external phone number
On red when
activated
Code:55
Operation: Do not lift handset + Press
key + Enter extension number + Enter
name + Press HOLD
Name Storing Changing the name dis-
played on your display
phone
None
Code:56 Automatic Transfer On red when active
Code:57
Department Incoming Call -
Delayed
Code: 58 + Dept. Group (1-32)
Department Incoming Call -
Immediate
Code: 59 + Dept. Group (1-32)
Department Incoming Call -
Delay
Code:60 + Dept. Group (1-64)
Department Incoming Call -
DND
Code: 63
Outgoing Call Without Caller
ID (ISDN)
On red when active
Code: 67 + Ext or Department
Group number
Operation: Press key
Voice Mail
Calling Voice Mail or
leaving a message
Flashes red on your
key for your
messages or red for
the Department
Group
Code:68 + 0-2
Operation: Press key
Using Voice Mail
Service
Flashes slowly when
monitoring
Code: 69 + 0
Operation: Set up call + Press key
Using Voice Mail
Record
Slow Flash red
when active
Code: 70 + Ext. # or Dept. Group
(1-32)
Automated Attendant
for Extension
None
Table 3-2: Function Key Codes by Number
To program a key, press CALL, dial 851 (for 2-digit codes) or 852 (for 3-digit codes), press the key and
enter the code.
Use this key... For this feature... When you are... Key Lamp Status