NEC XN120 - Page 23

Test the System
XN120 Expansion Unit Guide 23
Test the Exchange Lines
Test each line in turn, only test the lines that you have connected.
Use an XN120 system phone that you have previously confirmed is working correctly to test the exchange
lines.
1
To test CO1 connection
At an XN120 system phone lift
the handset and
dial 805 xx
(xx is the exchange line
number – refer to the Ports
Assigned section)
If you hear exchange dialing tone the line is working correctly.
If you do not hear exchange dialing tone move to step 2.
2 Check the connections. Check the connections from the exchange line to the XN120, ensure
both wires are connected to CO1 as shown on page 17.
3
To test CO2 connection
At an XN120 system phone lift
the handset and
dial 805 xx
(xx is the exchange line
number – refer to the Ports
Assigned section)
If you hear exchange dialing tone the line is working correctly.
If you do not hear exchange dialing tone check the connections from
the exchange line to the XN120, ensure both wires are connected to
CO2 as shown on page 17.
4
To test CO3 connection
At an XN120 system phone lift
the handset and
dial 805 xx
(xx is the exchange line
number – refer to the Ports
Assigned section)
If you hear exchange dialing tone the line is working correctly.
If you do not hear exchange dialing tone check the connections from
the exchange line to the XN120, ensure both wires are connected to
CO3 as shown on page 17.