NEC XN120 - Outgoing Exchange Line Access; Program 15-06-01; Program 14-07-01

Configure the Expansion Unit
XN120 Expansion Unit Guide 31
Outgoing Exchange Line Access
You may want to change this setting if:
· You want a dedicated exchange line for one of the telephones.
System Operation:
Each telephone is assigned a Trunk Access Map (TAM) number.
The TAM number is then given the access properties for each of the exchange lines.
The default operation is that all telephones have access to any exchange line.
1
Program 15-06-01
Give the telephone a TAM
number.
You can specify a different
TAM number for each
day/night mode.
See Changing the Telephone
Ringing Assignment for the
modes you may be using.
Default Setting:
All telephones have TAM number 1.
Ø Enter the TAM number (1-51) for each mode (1-8), you can
overwrite the current entry.
Ø Press HOLD to confirm the entry and step to the next mode.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
2
Program 14-07-01
Give each exchange line the
access properties for the TAM
number.
Default Setting:
Each exchange line has full access (Property type 7) for TAM number
1.
Therefore every telephone can access any of the trunks.
Ø Enter the access properties (0-7) for each trunk, you can
overwrite the current entry.
0 – No access
1 – Outgoing only
2 – Incoming only
3 – Retrieve held call only
4 – Outgoing and retrieve held call
5 – Incoming and retrieve held call
6 – Incoming and outgoing
7 – Incoming, outgoing and retrieve held call
Ø Press HOLD to confirm the entry and step to the next mode.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
See Also:
Changing the Telephone Ringing Assignment.
15-06-01 Tel 200
Mode1 Acc-Ma
p
1
Press Vol p q
to select the
telephone
number
Press HOLD to
select the next
mode
14-07-01 Acs.Ma1
Trk01 = 7
Press Vol p q
to select the
TAM number
Press HOLD to
select the next
trunk