NEC XN120 - Page 32

Configure the Expansion Unit
32 XN120 Expansion Unit Guide
Configuration Sheet: Outgoing Exchange Line Access
With defaults shown.
Give each telephone of the expansion unit a TAM number.
TAM Number (1-51)
for each day/night mode (1-8)
Default=TAM1 for all modes
Program 15-06-01
Telephone number
(from the configuration sheet
on page 21)
1 2 3 4 5 6 7 8
Give each exchange line of the expansion unit the access properties for the TAM number.
Program 14-07-01
TAM
Number
(1-51)
Trunk
number
Trunk
number
Trunk
number
7 7 7
0 0 0
0 0 0
0 0 0
0 0 0
Values available:
0 – No access
1 – Outgoing only
2 – Incoming only
3 – Retrieve held call only
4 – Outgoing and retrieve held call
5 – Incoming and retrieve held call
6 – Incoming and outgoing
7 – Incoming, outgoing and retrieve held call
Although there are 51 TAM numbers available only 5 are listed as this is normally sufficient.