Configure the Expansion Unit
28 XN120 Expansion Unit Guide
Telephone Ringing Assignment.
You may want to change this setting if:
· You want one, or more, exchange lines to ring at one or more telephones.
· You want a dedicated exchange line to ring at a specific telephone.
· You want exchange lines to ring at different locations throughout the day or at the weekend.
System Operation:
The ringing assignment is achieved by pointing the exchange line to Incoming Ring Groups. The ring group
then contains the telephones that will ring.
· Route each exchange line to an Incoming Ring Group (IRG) in Program 22-05-01. A line can route to a
different IRG in each night mode.
· You then place telephones into IRG’s in program 22-04-01, a phone can be a member of more than one
IRG. Up to 32 telephones can be entered per IRG.
The default operation is for each exchange line to ring at telephone 200.
The day/night mode is selected by keys at an XN120 telephone, simply press the key that corresponds to the
mode you require.
1
Program 22-05-01
The Incoming Ring Group
(IRG) number is assigned to
the exchange lines.
Refer to the configuration
sheet for the exchange line
port numbers and telephone
port numbers assigned to the
expansion unit.
Different IRG’s can be
assigned to each exchange
line to give different ring
assignment throughout the
day.
Default Setting:
Each line is assigned to Incoming Ring Group (IRG) number 1.
Default Setting:
There are up to 8 settings available for each line.
IRG number 1 is used for all 8 settings.
Therefore, each exchange line will ring at IRG 1 (and therefore
telephone number 200, regardless of the time of day.
Ø Enter the new IRG number (1-25), you can overwrite the
current entry.
Ø To remove an entry press CLEAR.
Ø Press HOLD to confirm the entry and step to the next mode.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
22-05-01 Trunk 9
Mode1 IRG =1
Press Vol p q
to select the
trunk number
Press HOLD to
select the next
mode
Route each line to a Ring
Group.
You can have a different
Ring Group per night mode.
Program 22-05-01
Assign telephones to the
Ring Groups.
Program 22-04-01
To Next Page
Loading...
