Configure the Expansion Unit
XN120 Expansion Unit Guide 29
2
Program 22-04-01
The telephones are placed into
ring groups (IRG’s).
Default Setting:
Telephone number 200 is a member of IRG number 1.
Ø Enter the new telephone number, you can overwrite the
current entry.
Ø To remove an entry press CLEAR.
Ø Press HOLD to confirm the entry and step to the next member.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
3
Program 20-07-01
Turn on the day/night mode
option.
Default Setting:
Day/night modes cannot be changed by any telephones.
Ø Enter 1 to enable the option, you can overwrite the current
entry.
Ø Press HOLD to confirm the entry and step to the next option.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
4
Assign a key to each
mode
Choose a telephone that will
be able to change the mode.
The keys are set at the
telephone itself.
Default Setting:
There are no keys set to day/night modes on any of the telephones.
1. At the telephone press SPK.
2. Dial service code 851
3. Press the Key you want to set (Its current setting is shown
if you have an LCD display).
4. Dial 09 followed by the mode number 1 to 8.
5. Repeat steps 3. and 4. for further keys/modes.
See also:
Outgoing Exchange Line Access to give a telephone a dedicated line for outgoing calls.
20-07-01 F-Cls 1
SW Man NT serv 0
Enter 1 to
enable
Day/night mode
option
22-04-01 INC Gr1
Memb.01= 200
Press Vol p q
to select the
IRG number
Press HOLD to
select the next
member
To Next Page
Loading...
