NEC XN120 - Create an Internal Paging Group; Program 31-02-01

Configure the Expansion Unit
38 XN120 Expansion Unit Guide
Create an Internal Paging Group
You may want to change this setting if:
· You want to make a paging call. The paging will be broadcast out of the loudspeakers of the XN120
system phones.
Paging is useful if you have staff that leave their desk and you need to contact them.
System Operation:
You add the XN120 system phones into a paging group. There are 32 paging groups available.
Program 31-02-01
Place the telephones into
paging groups.
You can only broadcast the
paging call out of the
loudspeakers of XN120
system phones, not normal
telephones.
The internal all call page
option is not mandatory; you
can leave this set to 0.
Default Setting:
None of the telephones are in a paging group.
Ø For each telephone enter the paging group number (0-32,
enter 0 to remove the phone from a group), you can overwrite
the current entry.
Ø Press HOLD to confirm the entry and step to the next option.
Ø Enter 1 to place the telephone in the Internal All Call Page
option
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
See Also:
There are no related settings.
Configuration Sheet:
With defaults shown.
Telephone
number
Page Group
Number
31-02-01
default=0 None
All call
page
31-02-02
default=0 No
31-02-01 Tel200
INT PG GP No 0
Press Vol p q
to select the
telephone
number
31-02-02 Tel200
INT ALL Call PG0
Press Vol p q
to select the
telephone
number