Necta brio 3 - Technician Menu - Machine Parameters; 2.3.1 Boiler Temperature; 2.3.2 Water Tank Configuration; 2.3.3 Mixer Heating

P2595EN01
08 - 2007

18
2.3 - MACHINE PARAM.
2.3.1 - BOILER TEMPERAT.
2.3.2 - TANK
2.3.3 - MIXER HEATING
2.3.4 - MIXER COOLING
2.3.5 - FAST CYCLES
2.3
ve n d I n g m a c h I n e P a r a m e t e r s
2.3.1
bo I l e r t e m P e r a t u r e
This function is used for setting the operating temperature, ex-
pressed in °C, of the boilers actually installed in the machine.
After selecting the boiler, press the conrm button “

”, the tempera-
ture value on the display will start blinking and can be modied as
necessary.
2.3.2
t
a n k
The machine water supply can be from the mains or from an internal
tank. For some applications it is also possible to use two internal
tanks at the same time.
With this function it is possible to dene whether the machine water
supply is from the mains (tank = 0) or from the tanks (tank = 1 or 2).
2.3.3
m
I x e r h e a t I n g
With this function it is possible to heat the mixer with a small amount
of hot water before dispensing, as long as the following conditions
are met:
- the rst water dose composing the drink is below 60 cc;
- no hot drinks have been dispensed from the mixer in the last 3 min-
utes, or no cold drinks have been dispensed in the last 5 minutes.
2.3.4
m
I x e r c o o l I n g (o n l y f o r m a c h I n e s w I t h a c o l d u n I t )
With this function it is possible to cool the mixer with a small amount
of cold water before dispensing, if no cold drinks have been dis-
pensed from the mixer in the last 5 minutes, or no hot drinks have
been dispensed in the last 3 minutes.
2.3.5
f
a s t c y c l e s
When this function is enabled, some of the time that is useful for
improving the drink quality is eliminated: all products that compose
the drink are dispensed at the same time, eliminating the “post-
whipping” time.