Necta brio 3 - Coin Mechanism Settings; Validator and Executive System Settings; BDV Protocol Settings

P2595EN01
08 - 2007
off
In the event of conguring the machine in a bank, this setting permits the control of 2 payment systems in-
stalled in 2 vending machines, so that when one payment system fails or no longer works, automatically the
other payment system becomes functional for the bank of machines.
va l I d a t o r s
When the “Validator Lines” function (line programming) of the “programming” menu is displayed, the value of
the 6 Validator coin lines, A to F, can be changed.
ex e c u t I v e
The following payments systems are available for the Executive system:
- Standard
- Price Holding
- Coges
- U-Key
- Sida
bdv
The BDV protocol menus are used for dening the following functions:

Setting the operating mode for multiple or single dispensing. With multiple dispensing, the change is not
automatically returned after a successful selection; however the credit is available for further selections. When
pressing the coin return button, the available credit is returned if its value is lower than the maximum change
value.

This function enables/disables the return of credit if no selections are made.
If enabled, this function allows the return of coins even if the rst selection was not dispensed.
If however a selection fails for any reason, the change will be returned if requested.

This function is used to dene the maximum accepted credit.

It is possible to set a limit to the total amount of change returned by the coin mechanism when pressing the
coin return button or after a single dispensing serving.
Any credit exceeding the amount programmed with this function will be cashed.

It is possible to dene which, among the coins recognised by the validator, are to be accepted.
Check the label on the coin mechanism for the correct coin to value matching, indicating the position of the
coins.
Non accepted coins
This function programs the rejection of coins when in "exact amount" mode.
Check the label on the coin mechanism for the correct coin to value matching, indicating the position of the
coins.
Dispensing buttons
This function enables or not the buttons on the coin mechanism used to release the coins in the change return
tubes.
co I n me c h a n I s m se t t I n g s
44